The current rush can lead to delays in shipments of palletized freight.
Recommended products
REAR WINDOW BLINKER LED LAMP 6 TO 12V, 60 CM is available to buy in increments of 1
Description
Length: 60 cm
This saftey light bar is designed to increase your visibility, It complements the original equipment of the vehicle, which is often poorly or not well visible.
It has the 4 main lighting functions on a single support placed on the rear window of your vintage car thanks to 2 suction cups. (POSITION, STOP, LEFT FLASH, RIGHT FLASH) + Warning.
It is equipped with a 3 m long flexible multicore cable with a 5-pin connector.
The Multifunctional LED Bar is detachable, the cable remains attached to the vehicle and is almost invisible, you can remove it from the rear window if you want to keep the look of your vintage car in ORIGINAL condition during a presentation or a race.
You will also be able to repair it with double-sided Stick if you want permanent mounting. Just remove the suction cups.
It works indifferently on a 6v or 12v voltage, without adjustments. It consumes only 10w in total of the 4 functions.
The connection is very simple, just connect a rear light for the 2 Position/Stop functions and on each of the rear turn signals for the Trun functions - the ground is common to all functions. Only 5 wires need to be connected (see: colour code).
However, it is strongly recommended that the original bulbs and indicators are replaced with LEDs to avoid ground loops. These earth loops can interfere with the proper functioning of the rods.
Today, replacing halogen, xenon and LED bulbs is not allowed under current legislation. In the EU, car parts must be certified according to UN/ECE specifications for use on public roads. Current ECE certificates only apply to halogen, xenon and LED lamps installed in new vehicles: However, there are no specific approval requirements or restrictions on the use of retrofit LED lamps on private roads.
We found other products you might like!
